Mission Critical Xantrex XanbusSCP Guide Du Propriétaire page 21

To surface mount the SCP:
1. Using the supplied template sticker as a guide, mark the
locations for two mounting screws and the access hole for
the Xanbus cables.
2. Using a hole saw, cut out the access hole for the Xanbus
cable(s).
3. Route the Xanbus cable(s) from other Xanbus-enabled
devices inside the wall and through the access hole.
4. Attach the mounting bracket with two #6 screws.
5. Connect the Xanbus cable(s) (and terminator if necessary)
to either network input on the back of the SCP.
Connect a network terminator to the SCP if it is the last
device at the end of a daisy chain network layout.
IMPORTANT:
To ensure communication signal quality, the network must
be terminated at each end with a terminator.
6. Place the unit into the mounting bracket and secure it with
four #6 screws. See "Securing the SCP" below.
7. Peel off the protective plastic coating covering the screen
and indicator light.
975-1171-01-01
Figure 11 Securing the SCP
21