Mission Critical Xantrex XanbusSCP Guide Du Propriétaire page 18

NOTICE
EQUIPMENT DAMAGE
Provide adequate space within the wall for the Xanbus cables to
bend. Do not bend the cable to one side after it leaves the Xanbus
port. The mounting bracket itself does not provide enough space for
the cables to bend. Attempting to route the cables through the side
of the mounting bracket without providing space for the cables
within the wall may damage to the SCP Xanbus ports and cause
network communication problems.
Failure to follow these instructions can result in equipment
damage.
To flush mount the SCP with mounting plate:
1. Using a jigsaw and the supplied template sticker as a guide,
cut out the hole for the mounting plate. The mounting plate
fastens to walls up to 19 mm thick.
2. Route the Xanbus cable(s) inside the wall and through the
opening.
3. Insert the mounting plate with the two tabs in a vertical
position into the hole (see "Inserting the Mounting Plate"
below).
18
Figure 7 Inserting the Mounting Plate
4. Secure the mounting plate by tightening the two screws to
rotate the tabs to the horizontal position (see "Securing the
Mounting Plate" on the facing page) and pull the tabs tight
against the inner surface of the wall. Be careful not to
overtighten the screws and damage the wall.
Xanbus System Control Panel (SCP) Owner's Guide