Mission Critical Xantrex XanbusSCP Guide Du Propriétaire page 34

Setting the Time
Because the SCP keeps time for the power system, setting the
clock to the correct local time is essential for the system to
operate as expected. The clock also provides the time stamps for
the Warning and Fault logs.
When you first power up the SCP, it will not begin operating
normally until you set the time.
NOTE
The SCP does not automatically adjust for Daylight Savings
Time or leap year.
34
To set the clock:
1. On the Clock menu, with Set Time highlighted, press
Enter.
The hour value is highlighted.
2. Press the up arrow or down arrow button to change the
hour.
3. When the correct hour is shown, press Enter to select it
and highlight the minute.
If you make an error, press Exit to move back to the value
you need to reset. If you decide to abandon resetting the
time, press Exit repeatedly until you return to the Clock
menu.
4. Press the up arrow or down arrow button to change the
minute.
5. When the correct minute is shown, press Enter to select it
and highlight the AM/PM value.
If you are using a 24-hour clock, you will return to Set Time
at this point. Proceed to step 8.
6. Press the up arrow or down arrow button to choose AM or PM.
7. When the correct value is shown, press Enter to select it
and return to the Clock menu.
8. Press Exit to return to the Select Device menu.
If you make an error, press Exit to move back to the value
you need to reset. If you decide to abandon resetting the
time, press Exit repeatedly until you return to the Clock
menu.
Xanbus System Control Panel (SCP) Owner's Guide