Publicité
Les langues disponibles
Les langues disponibles
Electrical Connections
Before Wiring Connection
/-N
Note:
For installation in cars with trip or navigational computers, all electronic memory settings previously
registered in the computer will be lost when the battery terminal is disconnected. Do not disconnect the
battery in vehicles equipped with these units. Therefore, extra care should be taken to prevent short*
circuits.
v_;
• This unit can be connected to an optional CD changer (CX-DP801EUC and optional extension cord).
For details, consult your nearest Panasonic dealers.
• For connection to a CD changer, refer to the operating instructions of the CD changer {CX-DP801 EUC).
-----—--X
Caution:
• To prevent damage to the unit, be sure to follow the connection diagram as follows.
• Remove about 5 mm of protective covering from the ends of the leads before connecting.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all
cables and keep cable terminals free from touching any metal parts,
v--------—_____.
Wiring Accessories
Accessory
Quantity
Power Connector
1
(CD/MD • C-1N)
w
CQ-MRX777EUC
(REAR VIEW)
(AUX-IN)
(PRE-OUT)
(tr
(REAR)
Red (R)
CD Changer
White (L)
Input Cord
Red (R)
AUX Input Cord
White (L)
Red (R)
Preamplifier Output Cord
White (L)
(For PRE-OUT setting)
Red (R)
Preamplifier Output Cord
White (L)
(Fixed to the rear speakers)
2
.
Radio Antenna Jack Q*=
Fr3
CD Changer
Connector
Auto antenna control power cord
(Connect it to the auto antenna control
power cord ol the car.)
(ANT-CONT MAX0.1 A)
(Blue)
Do not connect the auto antenna control
power cord directly to the power terminal
for driving the auto antenna (Otherwise, it
will cause trouble).
CD changer
control cord
(TWIN CD • C-CONT)
C3=o=--
'
1
(Brown w/white stripe)
(White w/Black Stripe)
(FRONT L)
(FRONT R)
J
.. Power connector
•
Leave Ihe NAVI MUTE cord unconnected,
and insulate it with vinyl tape or the like.
(an accessory)
(NAVI MUTE)
-
cd
-rns NAVI mute cord
(Orange)
' Connect the illumination cord to the power
line connected to the clearance lights of
(ILLUMINATION)
the car. (See note below.)
(Orange w/white stripe)
=f!B Illumination cord
Connect the accessories power cord to the
ACC power connector of the car._
(ACC)
(Red)
Resistor (Ikfl)
(Black)
Accessories power cord
(To the ACC power supply of the car)
_ GROUND
(To a metal part of the car body)
(Connect the battery power cord to a termi-
nal which is always live.
(BATTERY10A)
(Yellow)
Fuse (10A)
(AMP-CONT MAX 0.1 A)
Battery power cord
(Connect to car battery)
(Blue w/White stripe)
(REAR L)
(REAR R)
External amplifier control
power cord (Connect it to an
external amplifier.)
(White) £
(+)(")
Speaker cords
(Green)
_ _(Gray w/Black
_ _
(+)(-) Stnpe}
(+)(-)
(Green w/black Stripe)
(Violet w/Black Stripe)
(+)(")
LEFT SPEAKER RIGHT SPEAKER
(FRONT)
(FRONT)
LEFT SPEAKER RIGHT SPEAKER
(REAR)
(REAR)
Note:
If your car does not have a power line
connected to the clearance lights of the
car, leave the illumination cord uncon¬
nected.
52
CQ-MRX777EUC
Publicité
