Publicité
Les langues disponibles
Les langues disponibles
Pre-out (External Output) Setting
Pre-out (External Output) Switching
Connect an optional power amplifier (CY-M9054EUC, for example) and set it to suit your system.
Your unit has a preout for rear output and another for Sub-woofer/front/rear output. The operating proce¬
dures for the possible setting of preout (Sub-woofer/front/rear) outputs are described in this section.
• Sub-woofer output if an external amplifier or a Sub-woofer with a built-in amplifier is connected
• Through output if a system-up speaker is connected
Sub-woofer Output (SUB * W) Mode Setting
• The SUB-W indicator blinks during adjustment and lights steadily when the mode is set.
-
Note:
• Sub-woofer output is monaural and does not change even if the volume balance of the built-in ampli¬
fier is adjusted. (See Fader, page 28.)
• In Sub-woofer output mode, BAL/FAD, POSITION, SBC/SBC-SW, DRCII and SPACE effects are
invalid.
V-
j
Selecting a Sub-woofer Output
Setting Item
(D
Press and hold SPC(SUB*W) for more than 2 seconds to change to
the preout setting mode.
(D Press VOL V to display "PREOUT SUB-W".
•X Press V when using a remote control.
(D With Sub-woofer output selected, press SPC(SUBW) to change to
the SUB * W mode as follows.
—► LEVEL SELECT: Volume Adjustment
I
DELAY SELECT: Delay Time Adjustment
i
— FREQ SELECT: Setting Cutoff Frequency
-
Note:
When a setting mode is selected but no operation is made within
5 seconds, the display will return to the regular operation mode.
V_
)
CQ-MRX777EUC
33
Publicité
