MINN KOTA TERROVA Instructions D'installation page 32

INSTALLING THE PROP
3
e. Holding the end of the Armature Shaft with a Flat
Blade Screwdriver, tighten the Prop Nut with a 9/16"
Box End or Open End Wrench.
f. Tighten the Prop Nut 1/4 turn past snug to
25-35 in-lbs.
CAUTION
Do not over-tighten as this can damage the Prop.
32 | minnkota.johnsonoutdoors.com
Prop Nut Prop Nut
Prop Washer Prop Washer
Prop Prop
©2024 Johnson Outdoors Marine Electronics, Inc.
Drive Pin Drive Pin