MINN KOTA TERROVA Instructions D'installation page 28

SECURING ACCESSORY CABLES
Securing Accessory Cables
Before securing the cables, please review the "Identifying Trolling
Motor Features and Their Associated Cables" section of this
document. When identifying features, it is very important to secure the cables if two connections are present below the Control Head. If
only one cable is present below the Control Head, securing the Accessory Cables is not necessary. All Accessory Cables that will be used
on the trolling motor must be routed and all connections secured before completing the installation in this section. To review how feature
cables should be routed and connected, please review the "Advanced GPS Navigation" and "Dual Spectrum CHIRP" or "Built-in MEGA
Down Imaging" sections of this document.
Mount Mount
Failure to follow the recommended wire routing for installed features, if equipped, may cause damage to the product and void your
product warranty. Route cables away from pinch points or other areas that may cause them to bend in sharp angles. Routing the cables
in any way other than directed may cause damage to the cables by being pinched or severed. Do not over-tighten the cable ties as it may
damage the wires.
28 | minnkota.johnsonoutdoors.com
Foot Pedal Foot Pedal
Power Connector Power Connector
Dual Spectrum Dual Spectrum
CHIRP or CHIRP or
Built-in MEGA Built-in MEGA
Down Imaging Down Imaging
CAUTION
NOTICE: If only one cable is present below the Control
Head, this installation is not applicable.
Power Leads Power Leads
Advanced GPS Advanced GPS
Navigation Navigation
Coil Cord Coil Cord
Advanced GPS Advanced GPS
Navigation Navigation
©2024 Johnson Outdoors Marine Electronics, Inc.
Control Control
Head Head