MINN KOTA TERROVA Instructions D'installation page 30

SECURING ACCESSORY CABLES
3
e. Follow the Accessory Cables from the Control Head to
the Mount and place additional Cable Ties every 4–6
inches. The number of Cable Ties needed will vary
depending on the length of the trolling motor Shaft.
NOTICE: If additional Cable Ties are needed, a Cable
Tie Bag Assembly (Part #2996300) is available from the
Parts Ordering Portal at minnkota.johnsonoutdoors.com.
NOTICE: Secure the Cable Ties fingertip tight. It is
recommended to have them ONLY tight enough so that
they do not slide around on the Accessory Cables and
hold the Cables together.
4
f. Continue placing Cable Ties every 4–6 inches along
the Accessory Cables until there are two Cable Ties
in place past the end of the Coil Cord where it enters
the Mount.
g. Look at the placement of the Cable Ties and make
sure that at least two Cable Ties are present on the
Accessory Cables after they exit the Coil Cord. If
no additional Cable Ties are needed, make sure to
properly reconnect any Accessory Cables that may
have been disconnected.
h. Bundle any excess cable in a loose loop no less than
4" in diameter. The Reusable Cable Tie can be used
to secure excess cable.
30 | minnkota.johnsonoutdoors.com
3e
Cable Tie Cable Tie
Cable Tie Cable Tie
Cable Tie Cable Tie
Cable Tie Cable Tie
4g
Approximately Approximately
4–6 inches 4–6 inches
Approximately Approximately
4–6 inches 4–6 inches
Mount Mount
Control Head Control Head
Approximately Approximately
4–6 inches 4–6 inches
Approximately Approximately
4–6 inches 4–6 inches
Approximately Approximately
4–6 inches 4–6 inches
Mount Mount
Coil Coil
Cord Cord
Cable Tie Cable Tie
First Cable First Cable
Tie past Tie past
Coil Cord Coil Cord
Second Cable Tie Second Cable Tie
past Coil Cord past Coil Cord
Reusable Reusable
Cable Tie Cable Tie
©2024 Johnson Outdoors Marine Electronics, Inc.