MINN KOTA TERROVA Instructions D'installation page 25

2
ITEM(S) NEEDED
c. Identify the keyed Receptacle on the Ethernet
Cable (Item #14). It will be keyed to fit with the Eight
Pin Advanced GPS Ethernet Connector below the
Control Head.
NOTICE: The Ethernet Cable has a Receptacle for the
Advanced GPS Ethernet Connector on both ends. Either
end may be connected.
NOTICE: The 30' Ethernet Cable
Ethernet Cable - 720073-4) is provided. Alternate
cable lengths are available from
johnsonoutdoors.com.
3
d. If NO Sonar is present, take the Receptacle on
the Ethernet Cable and run it through the center of
the Coil Cord, starting at the end of the Coil Cord
attached to the Mount and working up towards
the Control Head. Allow enough slack in the cable
to attach the Receptacle to the Advanced GPS
Ethernet Connector.
NOTICE: Minn Kota recommends routing the Ethernet
Cable through the Coil Cord when making the Ethernet
connection. Bypassing the Coil Cord when routing the
Ethernet Cable is not recommended.
©2024 Johnson Outdoors Marine Electronics, Inc.
#14 x 1
(AS EC 30E - 30'
humminbird.
ADVANCED GPS NAVIGATION
2c
Control Control
Head Head
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Coil Cord Coil Cord
Control Head Control Head
3d
Ethernet Cable Ethernet Cable
Advanced Advanced
GPS GPS
Ethernet Ethernet
Connector Connector
Mount Mount
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Eight Pin Eight Pin
Connector Connector
Ethernet Cable Ethernet Cable
Mount Mount
Receptacle Receptacle
Ethernet Cable Ethernet Cable
minnkota.johnsonoutdoors.com | 25