MINN KOTA TERROVA Instructions D'installation page 13

If TWO connectors are present below the Control Head, the trolling
motor will be equipped with:
Advanced GPS Navigation & Dual Spectrum CHIRP or Built-in
MEGA Down Imaging - If Advanced GPS Navigation is pre-
installed on your trolling motor, one Eight Pin Advanced GPS
Ethernet Connector will exit the base of the Control Head and
rest just below the Control Head next to the Coil Cord. If the
Advanced GPS Navigation on the trolling motor will be used
with a fish finder, an Ethernet Cable may be attached to the
Advanced GPS Ethernet Connector below the Control Head.
See the "Advanced GPS Navigation" section of this document
for details on how to install the Advanced GPS Ethernet
Connector to a Humminbird.
If Dual Spectrum CHIRP or Built-in MEGA Down Imaging is
pre-installed on your trolling motor, one Sonar Accessory Cable
will exit the base of the Control Head and run down the center
of the Coil Cord. The end of the Cable will have a Fourteen Pin
Connector. Motors with Dual Spectrum CHIRP or Built-in MEGA
Down Imaging will also have a transducer in the Lower Unit. The
appearance of the transducer will vary depending on sonar type.
©2024 Johnson Outdoors Marine Electronics, Inc.
IDENTIFYING CONNECTORS
TWO Connectors
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Fourteen Pin Fourteen Pin
Built-in MEGA Down Built-in MEGA Down
Imaging Imaging
or Dual Spectrum or Dual Spectrum
CHIRP CHIRP
Dual Spectrum CHIRP
Control Control
Head Head
Eight Pin Eight Pin
Connector Connector
Advanced Advanced
Connector Connector
GPS GPS
Ethernet Ethernet
Connector Connector
Coil Coil
Cord Cord
Mount Mount
Built-in MEGA Down Imaging
minnkota.johnsonoutdoors.com | 13