MINN KOTA TERROVA Instructions D'installation page 29

1
a. Place the motor in the stowed position. Confirm all
Accessory Cables are connected to an output device
as desired.
b. To secure the Accessory Cables, the Sonar Cable
and Ethernet Cable will be tied together inside the
Coil Cord using Cable Ties. Ensure the Accessory
Cables are parallel to each other inside the Coil
Cord. Run the Accessory Cables from the Control
Head to the Mount, keeping them straight and
parallel the entire length.
NOTICE: The Sonar Cable comes from the factory
secured to the Coil Cord with a pre-installed Cable Tie.
Keep the pre-installed Cable Tie in place.
2
ITEM(S) NEEDED
c. Starting approximately 4–6 inches below the pre-
installed Cable Tie, take a new Cable Tie (Item #16)
and place it around the Sonar Cable and Ethernet
Cable. Do NOT capture the Coil Cord with the Cable
Tie. The Sonar Cable and Ethernet Cable should be
secured together with the Cable Tie but float freely
on the inside of the Coil Cord. Keep the pre-installed
Cable Tie in place.
NOTICE:
Do NOT secure the Accessory Cables to the
Coil Cord. ONLY secure the Sonar and Ethernet Cables
to each other using Cable Ties.
d. Secure the Cable Tie around the Accessory Cables
until it is fingertip tight. Do not over-tighten the
Cable Tie as it may damage the Cables.
CAUTION
Do not over-tighten the Cable Ties as it may damage the wires.
©2024 Johnson Outdoors Marine Electronics, Inc.
#16 x 10
SECURING ACCESSORY CABLES
1b
Advanced Advanced
GPS Ethernet GPS Ethernet
Connector Connector
Ethernet Ethernet
Cable Cable
2c
Pre-installed Pre-installed
Cable Tie Cable Tie
Cable Tie Cable Tie
Cable Tie Cable Tie
Pre-installed Pre-installed
Cable Tie Cable Tie
Sonar Cable Sonar Cable
Coil Cord Coil Cord
Approximately Approximately
4–6 inches 4–6 inches
Approximately Approximately
4–6 inches 4–6 inches
minnkota.johnsonoutdoors.com | 29