19. INSTALLING THE FLAME BROILER COMPONENTS
Parts Required:
1
x
Flame Broiler Main Plate (#32)
1
x
Flame Broiler Slider (#33)
Installation:
•
Insert the flame broiler main plate into the main grill, right side first.
Rest the flame broiler main plate on the built-in ledge (on the inside
right) of the main grill that directs grease towards the grease bucket.
Slide the entire piece to the left side, and the two slots on the flame
broiler main plate will fit into the rounded ledge above the fire pot. It
will sit slightly at a downward angle.
IMPORTANT: If the flame broiler main plate is on the base of the barrel,
it is installed incorrectly. The flame broiler main plate should sit at an
angle, with the left side sitting higher than the right. Poor installation of
this part may result in damage to your main grill barrel.
•
Place the flame broiler slider on top of the flame broiler main plate, covering
the slotted openings. Ensure the raised tab is on the left, to easily adjust for
direct or indirect flame when cooking. Both flame broiler parts are lightly
coated with oil to avoid rusting when shipped.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
20. INSTALLING THE FLAME BROILER ADJUSTING BAR
Parts Required:
Flame Broiler Adjusting Bar (#30)
1
x
Installation:
•
Put Flame Broiler Adjusting Bar into the chamber of the pellet grill and
push the Flame Broiler Adjusting Bar (To Flame Broiler Adjusting Bar handle
Side) pass through the chamber of pellet grill (shown as Step 20).
21. ATTACHING THE FLAME BROILER ADJUSTING BAR HANDLE
Parts Required:
1
x
Flame Broiler Adjusting Bar handle (#31)
Installation:
•
Mount Flame Broiler Adjusting Bar handle to the Flame Broiler Adjusting Bar.
•
Open the locker on the Flame Broiler Slider.
•
Put the Flame Broiler Adjusting Bar in the position.
•
Close the locker on the Flame Broiler Slider.
14
19
32
33
32
20
30
21
31
3
1
2
3