CYBEX ATON 2 Mode D'emploi page 31

Center Seating Positions
If your vehicle does not have Lower Anchors in the center seating position,
check your Vehicle Owner's Manual to see if you are allowed to use the two
inner Lower Anchors from the outboard seating positions to install a Child
Restraint.
CYBEX allows this child restraint to be installed using the two inner Lower
Anchors from the outboard seating positions if the distance between the
inner Lower Anchors is between 28-51 cm (11 and 20 inches) AND if your
vehicle manufacturer allows it. (If distance is not correct and/or not allowed
by vehicle manufacturer, use the vehicle belt for installation in the center
position.)
When using the inner Lower Anchors make sure there are no obstructions
from a buckle stalk for the installation and that the LATCH straps or mini
connectors do not block vehicle belt buckles.
Make sure there is enough height to use the Load Leg in the Center Seating
Position. Many vehicles have a hump in the floor that could cause the Load
Leg, even its shortest position, to push the Base above the vehicle seat
which will not allow proper installation. See page 30.
If using LATCH in the center seating position, ALWAYS check the vehicle
Owner's Manual for correct use of lower LATCH anchors.
Using LATCH Guides
1. Locate the lower LATCH anchors or the symbols indicating their location.
2. If the lower LATCH anchors are hidden behind the crease between
the seat back and seat cushion, install the supplied LATCH Guides to
the lower LATCH anchors for easier installation of the Aton 2 Base.
3. To install, connect the two LATCH Guides to the two
lower LATCH anchors by sliding the LATCH Guides into
the crease and under the lower LATCH anchors.
28
Using LATCH