Publicité
Les langues disponibles
Les langues disponibles
When mounting the oil filter cover, apply a layer of oil film on
the oil filter seal ring.
Clean the oil drain plug, magnet and oil strainer assy.
Replace with new o-ring, then install the oil drain plug (20N•m),
magnet and oil strainer assy�
Remove the oil filling plug and o-ring
Fill with 2800 ml oil of SAE10W/50.
Install the oil filling plug and o-ring.
Idle the engine for several minutes, and allow the oil run into the
oil filter.
Turn off the engine.
Inspect the oil level and adjust it according to the real level.
Engine Oil Capacity
Replacing oil filter: 3 qt (2.8 L)
CFMOTO recommends the kind of oil with APISJ or higher, with
JASO T903 MA2 as the primary choice.
Although 10W-50 oil is the recommended oil for most conditions,
the oil viscosity may need to be changed to accommodate
atmospheric conditions in your riding area. Please choose oil
viscosity according to the chart�
ENGINE ASSY
CAUTION
�
3
113
3
Publicité
