Storing; Scrapping A Machine; Environmental Information - Cormach FT 26S Manuel D'utilisation Et D'entretien

Picture F16.1
17. STORING
If the machine as to be stored for a long time (3 – 4 months) you have to:
1. Close the jaws of the chuck; low the chuck holding arm down; low the tool holding arm down, in working
position.
2. Disconnect the machine from all power sources.
3. Grease all the parts that could be damaged if they dry out:

The chuck

The slot of the tool holding arm

The slides of the carriage

The tool
4. Empty oil/hydraulic fluid reservoirs and wrap the machine in a sheet of protective plastic to prevent dust from
reaching the internal working parts.
If the machine as to working again after a long storing period, it is necessary to:

Put the oil into the reservoirs again.

With a turnscrew press the pin on the middle of the electro‐valves of the hydraulic power pack (See picture
F17.1) in order to manually unlock the electro‐valves which could be locked after a long period of inactivity.
Picture F17.1

Restore the electric connection.
18. SCRAPPING A MACHINE
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal parts and dispose of them
separately in accordance with current provisions as prescribed by law.
18.1 Environmental information
The disposal procedure described below only applies to machines with the symbol of the waste bin with a bar cross
it on their data plates.
Manuale/Manual/Manuel/Handbuch/Manual – 07/2014
Pagina 53