Identifying Controls; Working Position - Cormach FT 26S Manuel D'utilisation Et D'entretien

10. IDENTIFYING CONTROLS
The mobile control center (picture F8.2) enables the operator to work at any position around the machine. On this mobile
control center the following controls are located:

The lever (8, picture F8.2) which in position "a" lifts the chuck arm and in position "b" lowers it; in position "c" moves
the tool holder arm and the sliding table towards the self‐centering chuck and in position "d" moves them away
(Note: in order to memorize this operation, there is a hole in the lever guard corresponding to "c").

The chuck switch (9, picture F8.2) when moved up‐wards, opens the arms of the self‐centering chuck (LOCKING); and
when moved down closes the arm of the self‐centering chuck (UNLOCKING).

The pedal (10, picture F8.2) when pressed on the left or right side rotates the self‐centering chuck in the same
direction as shown by the arrows placed on the foot pedal. NOTE: all the controls are very sensitive and small
movements of the machine can be done with precision.
The tyre changer also has:
Lever (15, picture F8.3) to tip the tool carrier arm (14, picture F8.3) from its non‐working position and vice‐versa.
Handle (19, picture F8.3) that permits alternative use of the bead‐breaking disk (17, picture F8.3) or the hooked tool (18, picture
F8.3).
11. WORKING POSITION
The picture F11.1 illustrates the various working positions (A, B, C, D) referred to in the following pages describing how to use
the tyre changer. Use of these positions ensures greater precision, speed and safety for those using the machine.
a
d
Picture F11.1
Manuale/Manual/Manuel/Handbuch/Manual – 07/2014
3014036
3014056
3014030
Picture F9.1
b
c
3014034
3014033
Pagina 36