Cormach FT 26S Manuel D'utilisation Et D'entretien page 39

CAUTION: These measurements are also the tyre changers working range. Persons other than especially trained and authorized
operators are expressly forbidden to enter this area.
Position the tyre changer lifting it with the specific bracket (1, picture F7.2) with the tool carrier arm (2, picture F7.2)
lowered all the way, the spindle (3, picture F7.2) closed and tool carrier slide (4, picture F7.3) at its stop close to the arm.
It is not essential to anchor the machine to the floor. However, the floor must be smooth and permit the platform rollers
to move freely.
Electric hook‐up
Before making any electric hook‐up, check to be certain that the mains voltage corresponds to that stamped on the voltage
tag (attached to the cord near the tyre changer's plug).
It is absolutely essential that:

The system is equipped with a good grounding circuit.

The machine is connected to a power supply line circuit breaker set for 30 30 mA.

The current instake is adeguately protected against overcurrents with fuses or automatic magneto‐thermic
switch with rated values as shown in the table.
Note the required power draw as high‐lighted on the data plate fixed to the tyre changer. Check to make sure the shop
electric wiring circuit is dimensioned sufficiently to carry this.

Power Supply: 3 80V ‐ 3 Ph. ‐ 5 0/60Hz

Fuse: 20A AM

Remote control switch: 20A
Work on the electric system, even if minor, must be done exclusively by professionally qualified personnel.
Manufacturer shall not be liable for any injury to persons or damage to things caused by failure to comply with
these regulations and can cancel warranty coverage.
Manuale/Manual/Manuel/Handbuch/Manual – 07/2014
600 mm
2500 mm
Picture F7.1
Picture F7.2
Pagina 33