Transport; Unpacking; Installation; Installation Place - Cormach FT 26S Manuel D'utilisation Et D'entretien

Picture F4.3
4 – Pump motor overload cut‐out (inside the electric enclosure). This cuts in if the motor overheats to prevent it from burning out.
CAUTION: Removing or tampering with safeties is in violation of European Safety Regulations and relieves manufacturer of any
and all liability for injury to persons to damage to things caused or referable to such acts.
5. TRANSPORT
The machine is delivered in a wooden crate with pallet.
The machine must be handled with a fork‐lift truck with the forks positioned as shown in the picture F5.1.
Picture F5.1
Shipping weight for the machine is 775 Kg.
6. UNPACKING
Once the packing material has been removed, check the machine visually for any signs of damage.
Keep the packing materials out of the reach of children as they can be a source of danger.
N.B.: Keep the packing for possible future transport.
7. INSTALLATION
7.1 Installation place
Choose the place the machine is to be installed in compliance with current work place safety regulations. The floor should
not be broken or uneven so that the machine will be stable and the platform rollers can move freely.
If the installation is outdoor, it must be protected by some kind of roofing against rain.
The following work environment conditions are applicable:

Relative humidity from 30% to 95% without condensation;

Temperature from 0° to 55° C.
The machine must not be operated in explosive atmospheres.
Maximum machine space requirements are mm. 2085 x 1820, with a minimum distance from walls as shown in picture F7.1.
Manuale/Manual/Manuel/Handbuch/Manual – 07/2014
Pagina 32