Cormach FT 26S Manuel D'utilisation Et D'entretien page 56

Picture F13.27
9. Move the tool holder arm to its non‐working position and completely close the turntable clamps being careful
to support the wheel to keep it from falling.
This operation can be extremely dangerous. Perform it manually if you are absolutely
certain you can maintain the wheel equilibrium only. For heavy, large sized wheels you
MUST use a suitable lifting device.
10. Move the platform to move the wheel away from the turntable.
11. Remove the wheel.
Wheels with 5 – piece side rings
1. Move the tool holder arm to the non‐working position. If the rim has been removed from the turntable, reclamp
it as described in the "WHEEL CLAMPING" paragraph.
2. Lubricate the tyre beads and rim using the recommended soapy solution.
3. Take the mobile control unit to work position B.
4. Move the mobile platform outward in order to place the tyre on it.
5. Lower or lift the turntable in order to exactly center the rim to the tyre.
6. Move the platform inward to make the rim enter the tyre. Move it forward until it is completely inserted.
7. Insert the shoulder side ring on the rim (with the lock ring already mounted).
N.B.: if the rim and the side ring have slits for fixing devices, make sure they are lined up with each other.
8. Take the mobile control unit to work position C.
9. Move the tool holder arm to the external side then lower it to the working position with the bead breaker disk
turned towards the wheel.
N.B.: if the shoulder side ring is not sufficiently inserted on the rim, move the turntable until tyre bead is positioned
in correspondence of the bead breaker disk. Move the disk forward (and at the same time turn the turntable) until
the sealing O‐ring seat is "uncovered".
10. Lubricate the O‐ring and insert it in its seat.
11. Take the mobile control unit to work position B.
12. Put the locking ring on the rim with the help of the bead breaker disk as shown in picture F13.27.
13. Move the tool holder arm to its non‐working position and completely close the turntable clamps being careful
to support the wheel to keep it from falling.
This operation can be extremely dangerous. Perform it manually if you are absolutely
certain you can maintain the wheel equilibrium only. For heavy, large sized wheels you
MUST use a suitable lifting device.
14. Move the platform to move the wheel away from the turntable.
15. Remove the wheel.
Do not inflate the tyre with the wheel still mounted on the turntable. Tyre inflation is
dangerous ad should only be done by removing the wheel from the turntable and placing
it inside a safety cage.
Manuale/Manual/Manuel/Handbuch/Manual – 07/2014
Pagina 50