Cormach FT 26S Manuel D'utilisation Et D'entretien page 51

When the beads come off the rim the wheel will fall. Check to make sure there are no by‐
standers in the work area.
Mounting
1. If the rim has been removed from the spindle, put it back on the spindle as described in the section on
"CLAMPING THE WHEEL".
2. Lubricate both beads and the rim with tyre manufacturer recommended lubricant.
3. Attach the clip to the outside edge of the rim at the highest point (See picture F13.19).
Picture F13.19
Make sure the clip is firmly attached to the rim.
4. Take the mobile control unit to work position B.
5. Put the tyre on the platform and lower the spindle (make sure the clip is at the high point) to hook the first bead
on the clip.
6. Lift the rim with the tyre hook to it and turn it anticlockwise about 15‐20 cm. The tyre will be positioned tilted
across the rim.
7. Move the tool carrier arm to its non‐working position. Move it to the inside plane of the tyre and rehook it in
this position.
8. Check to make sure the hook tool is positioned on the wheel side. If not, press lever and turn it 180°.
9. Take the mobile control unit to work position D.
10. Move the tool forward until the red reference dot is lined up with the outside edge of the rim and about 5 mm
from it (See picture F13.20).
Picture F13.20
11. Take the mobile control unit to work position C.
12. Move to the outside of the wheel and check the exact position of the hook visually and adjust it as needed. Then
turn the spindle clockwise until the clip is at the bottom (6 o'clock). The first bead will be on the rim. Remove
the clip.
13. Take the mobile control unit to work position D.
14. Remove the tool from the tyre.
Manuale/Manual/Manuel/Handbuch/Manual – 07/2014
Pagina 45