Trouble Shooting; Moving The Machine - Cormach FT 26S Manuel D'utilisation Et D'entretien

1
4
3
4
1
Picture F14.2
N.B.: if the adjustment is insufficient and there is still play, adjust the screws further, repeating the procedure
described above until all mechanical play has been eliminated.
Dispose of the used oil following the present legislation on the matter.
15. TROUBLE SHOOTING
a. After having switched the general button on the electric pack, the general warning light does not light on and no
control can function.
Causes

The power plug is not inserted.

No power from the mains electric supply.
Remedies

Insert the plug correctly in its socket.

Reset the mains electric supply.
b. After having switched the general button on the general warning light also switches on but the motor on the
hydraulic power pack does not function.
Causes

The magneto‐thermic switch for motor protection is working.
Remedies

Call for technical aid to see what is the problem and restore the machine.
If, inspite of the above mentioned indications the tyre changer does not work properly, do
not use it and call for technical assistance.
16. MOVING THE MACHINE
The tyre changer has got a fork (1, picture F16.1) which has been positionned there on purpose for moving the
machine.
Follow these instructions:
1. Low the turntable holding arm (2, picture F16.1) completely down.
2. Close completely the jaws of the chuck (3, picture F16.1).
3. Bring the sliding table (4, picture F16.1) at the end of its travel, near the arm.
4. Insert into the lifting fork a hoisting belt (at least 60 mm wide and of a length sufficient to bring the hook of the
belt above the tyre changer).
5. With the special belt ring bring the 2 ends of the belt together and lift with a sufficiently strong lifting truck.
Manuale/Manual/Manuel/Handbuch/Manual – 07/2014
2
1
4
3
5
Pagina 52