EUROM Force 1401 Mode D'emploi page 44

Clean the nozzle(s)
1. Make sure the device is off.
2. Remove the water supply.
3. Remove the nozzle (Figure 18, pos. 2) from
the extension lance (Figure 5, pos. 2).
4. Clean the nozzle with the cleaning pin
(Figure 18, pos. 1).
5. Flush it thoroughly (against the direction of
the high-pressure jet).
Troubleshoot
CAUTION
Contact a EUROM authorized professional:
•
•
The following problems can occur:
Problem
The device does not
start.
Fluctuating
pressure.
44
in the event of regularly recurring errors;
if the errors are not solved.
Cause
Plug not in the
power outlet.
Power outlet not
working.
Extension cord
broken.
Pump is sucking in
air.
Valves are dirty,
worn or broken.
Pump seal work.
The nozzle is
partially blocked.
Figure 18
Solution
Plug the power plug
into the socket.
Use another power
outlet.
Contact a EUROM
authorized
professional.
Contact a EUROM
authorized
professional.
Contact a EUROM
authorized
professional.
Contact a EUROM
authorized
professional.
Clean the nozzle.
Safety instruction
Make sure the
device is off.
Make sure the
device is off.
Do not use the
device.
Do not use the
device.
Do not use the
device.
Do not use the
device.
Make sure the
device is off and
drained.