EUROM Force 1401 Mode D'emploi page 36

Brackets
1. Slide the power cable bracket
(Figure 8, pos. 1) onto the main body
(Figure 8, pos. 2).
2. Press firmly until you hear a 'click'.
3. Slide the jet gun bracket (Figure 8, pos. 4)
onto the main body (Figure 8, pos. 3).
4. Press firmly until you hear a 'click'.
Installation
CAUTION
Place the cleaner as close as possible to the water supply.
CAUTION
The cleaner must be placed upright on a solid, flat and horizontal surface
(handle on top).
Main body
CAUTION
The water hose and female water coupling are not included.
1. Make sure the device is correctly assembled.
2. Make sure the ON(I)/OFF(0) switch is in the OFF(0) position (Figure 9, pos. 5).
3. Place the power plug (Figure 9, pos. 3) into a socket that is easily accessible.
4. For the first use only: remove the protective cap from the high-pressure water outlet
(Figure 9, pos. 1).
5. Screw the high-pressure hose (Figure 9, pos. 2) to the high-pressure water outlet.
6. Connect the water supply to the device (Figure 9, pos. 4).
7. You will hear a
36
'click' when the water supply is correctly connected.
Figure 8