EUROM Force 1401 Mode D'emploi page 40

After operation
WARNING
If the device is off, left-over in the device can still be under high pressure.
CAUTION
•
•
•
1. Release the trigger (Figure 6, pos. 4).
2. Lock the safety lock under the trigger (Figure 6, pos. 3).
3. Switch the device off (Figure 4, pos. 11).
4. Pull the power plug out of the socket (Figure 4, pos. 7).
5. Wind the power cable.
6. Place the power cable on the bracket (Figure 4, pos. 8).
7. Close and disconnect the water supply.
8. Unlock the safety lock under the trigger.
9. Hold the jet gun with both hands.
10. Squeeze the trigger to drain the jet gun.
11. Unscrew the high-pressure (Figure 5, pos. 6) hose from the high-pressure outlet
(Figure 4, pos. 5).
12. Disconnect the high-pressure hose from the jet gun by pressing the tab (Figure 6, pos. 2)
forward.
13. Drain the high-pressure hose for at least 1 minute.
14. Remove the extension lance (Figure 5, pos. 2) from the jet gun by rotating it 90°.
15. Remove the nozzle (Figure 13, pos. 1) by
pressing the release button (Figure 13, pos. 2)
on the extension lance.
16. Place all the accessories on the designated
brackets of the device (Figure 4).
40
Do not use the power cable to unplug or carry the device.
Do not wind the power cable too tightly or in sharp angles.
Do not wrap the power cable around the device.
Figure 13