EUROM Force 1401 Mode D'emploi page 38

Extension lance and nozzle
1. Align the ridge of the nozzle (Figure 11, pos. 5) with the groove in the extension lance
(Figure 11, pos. 4).
2. Insert the nozzle (Figure 11, pos. 6) into the extension lance (Figure 11, pos. 7).
3. You will hear a 'click' when the nozzle is correctly connected.
4. Align the ridge of the extension lance (Figure 11, pos. 3) with the groove in the jet gun
(Figure 11, pos. 2).
5. Insert the extension lance (Figure 11, pos. 7) into the jet gun (Figure 11, pos. 1).
6. Turn the extension lance 90° degrees to secure the extension lance.
Figure 11
Operation
WARNING
Before operating, see section Safety.
WARNING
Operating the device more than 2 minutes without water leads to damage of
the high-pressure pump. If the appliance does not build up pressure within 2
minutes, switch the appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting".
CAUTION
If the lever of the jet gun is released, the pressure switch turns off the pump
and the high-pressure jet stops. The pump switches on again when the lever is
pressed.
38