EUROM Force 2201 Plus Mode D'emploi page 50

Problem
Device stops.
Blown fuse.
Device vibrates.
The device reg­
ularly starts and
stops by itself.
The device
starts but does
50
Cause Solution
The nozzle Clean the nozzle.
is partially
blocked.
Blown fuse. Contact a EUROM authorized
professional.
Active ther­ Allow to cool and remove the
mal safety. cause of overheating.
Nozzle is par­ Clean the nozzle.
tially blocked.
Electrical in­ Connect to an installation
stallation is with a higher amperage.
to light.
Do not use an extension ca­
ble.
Air in the wa­ Allow it to escape by running
ter supply water through the device
hose. while it is switched off.
Problem with Do not use an excessively
the water long or thin hose (min. 1/2".)
supply.
The nozzle Clean the nozzle.
is partially
blocked.
The water Clean the water filter.
inlet filter is
dirty.
There is a Straighten the hose.
kink in the
hose.
Pump or jet Have them repaired or re­
lance are placed.
leaking.
Pump, hose Allow them to thaw and
or acces­ check them.
Safety instruction
Make sure the device is off
and drained.
Do not use the device.
Make sure the device is off.
Do not use the device while
cooling off.
Make sure the device is off
and drained.
Make sure the device is off
when switching to another
electrical installation.
Make sure the device is off
when removing the exten­
sion cable.
Make sure the device is off.
Make sure the device is off
and drained when changing
a hose.
Make sure the device is off
and drained.
Make sure the device is off
and drained.
Make sure the device is off.
Contact a EUROM autho­
rized professional.
Do not use the device.