EUROM Force 2201 Plus Mode D'emploi page 46

Perform the following maintenance tasks after every use:
• Carefully remove dust, sand or other dirt from the connections (nozzle, extension lance, jet
gun, high-pressure hose and water inlet).
• Remove the nozzle from the extension lance. Regularly clean the nozzle with the supplied
pin. Flush it thoroughly (against the direction of the high-pressure jet).
Perform the following maintenance tasks regularly:
• Regularly Vaseline the O-rings of the connectors to prevent them from drying out.
• Clean the water inlet filter.
Grease O-rings
1. Pull the nozzle from the extension lance.
2. Apply Vaseline to the O-ring of the nozzle
(Figure 36, pos. 1).
3. Pull the floor cleaner from the extension
lance.
4. Apply Vaseline to the O-ring of the floor
cleaner (Figure
46
37, pos. 1).
Figure 36.
Figure 37.