EUROM Force 2201 Plus Mode D'emploi page 44

After operation
WARNING
If the device is off, left-over in the device can still be under high pressure.
CAUTION
• Do not use the power cable to unplug or carry the device.
• Do not wind the power cable too tightly or in sharp angles.
• Do not wrap the power cable around the device.
1. Release the trigger.
2. Lock the safety lock under the trigger.
3. Switch the device off.
4. Pull the power plug out of the socket.
5. Wind the power cable.
6. Place the power cable on the bracket.
7. Close and disconnect the water supply.
8. Unlock the safety lock under the trigger.
9. Hold the jet gun with both hands.
10. Squeeze the trigger to drain the jet gun.
11. Disconnect the high-pressure hose from the jet gun by pressing the button.
12. Drain the high-pressure hose for at least 1 minute.
13. Roll the high-pressure hose back onto the reel.
14. Remove the extension lance
15. Remove the nozzle or floor cleaner
(Figure 35, pos. 2) on the jet gun.
16. Place all the accessories on the designated brackets of the device
44
(Figure 25, pos. 2) from the jet gun by rotating it 90°.
(Figure 35, pos. 1) by pressing the release button
(Figure
Figure 35.
24).