Wireless Control Of A Somfy Rts Device Via The Monitor; Viewing / Deleting Photos - SOMFY V300 Manuel D'installation Et D'utilisation

Masquer les pouces Voir aussi pour V300:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
V300

8.4 Wireless control of a Somfy RTS device via the monitor

[1]. Selected the channel associated with the device that you want to control by pressing the SELECT button (8): the indicator light of
the channel selected flashes (or the 4 indicator lights flash for channel 5).
Press the channel selection button as many times as necessary until the indicator lights show the required channel.
[2]. Control your equipment using the Open/On, STOP and Close/Off buttons on the monitor.
The equipment will react as stated in the table below:
Equipment
controlled
Garage door
Open
Lighting
On
Roller shutter
Open
Gate
Open

8.5 Viewing / deleting photos

The monitor can store up to 100 photos in its internal memory: when the memory is full, the oldest photo is deleted and replaced by the new one.
For each call, the monitor saves a photo taken with the door station camera and the photo LED (10) comes on:
• If the call is not answered, the photo LED (10) remains lit to indicate that a new photo has been saved.
• If the calls is answered, the photo LED (10) goes out.
8.5.1 Viewing the photo(s)
Note: if the photo LED (10) is on, it goes out as soon as a photo is viewed.
For each photo, the sequence number and date and time it was taken are shown at the top of the screen.
To view the photos saved in the monitor's memory:
[1]. press one of the two settings buttons (16) briefly to see the last photo saved.
[2]. press one of the two settings buttons (16) briefly to browse the photos.
[3]. press the "Back" button (17) briefly to exit the photo viewer.
8.5.2 Deleting a photo
[1]. When you view a photo, press the "Menu" button (15) briefly: a deletion message appears on the screen.
[2]. Using the settings buttons (16), select "yes" to delete the photo or "no" to exit without deleting it: the parameter selected is
displayed in red.
[3]. Press the "Menu" button (15) to confirm your choice.
8.5.3 Deleting all photos saved
To delete all photos, you must exit the photo viewer.
[1]. Press the "Menu" button (15).
[2]. Press the "Menu" briefly several times until you reach the "Delete all" tab.
[3]. Press one of the settings buttons (16) to confirm that all photos are to be deleted: the message "Deleting" is displayed.
[4]. Press the "Back" button (17) to exit.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
10
5
Open/on
(5)
Stopped (if the door is moving)
-
• Stopped (if the roller shutter moving)
• Favourite position (if the roller shutter is stopped)
Stopped (if the gate is moving)
1
6
7
8
Press button:
STOP (6)
EN
Close/off
(7)
Closed
Off
Closed
Closed
20
15
17
16
17

Publicité

Table des Matières
loading

Table des Matières