Saving The Gate Motorisation In The Monitor's Memory; Operation; Responding To A Visitor; Opening The Gate - SOMFY V100+ Notice D'installation Et D'utilisation

Masquer les pouces Voir aussi pour V100+:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
EN

7.3 Saving the gate motorisation in the monitor's memory

• Bring the monitor to the gate motorisation and connect it using the mains adaptor (A).
• Open the motorisation cover to access the electronics
• Press on the power button
does not exist, continue directly to the next step). The indicator light
electronics.
• Place the lower central section of the monitor on the motorisation electronics target (B).
• Select a free channel on the monitor and press the PROG button (11), located at the
bottom right of the monitor (C), for 1 second.
The indicator light
• The motorisation is now saved in the monitor's memory. You can control the opening
and closing of your gate using the wireless control.
For more details, consult section concerning "Adding a 3-button remote control" in
the instruction manual of your SOMFY motorisation.

8.1 Responding to a visitor

When a visitor presses the call button on the door station, the monitor plays a ringtone and an image of the visitor is displayed.
Press the "microphone activation" button
You can communicate with your visitor.
Note: You can communicate with your visitor for a maximum of 2 minutes.
If you press the "microphone activation" button

8.2 Opening the gate

With the monitor screen switched on or off, press the "gate" button
If the monitor screen is on, the "gate" icon is displayed then the screen switches off when the gate opens.

8.3 Unlocking the electric latch/lock

With the monitor screen switched on or off, press the " electric latch/lock" button
If the monitor screen is on, the " electric latch/lock" icon is displayed then the screen switches off when unlocking.

8.4 Wirelessly controlling a Somfy RTS unit from the monitor

[1]. Selected the channel associated with the equipment that you want to control by pressing the channel selection
button: the indicator light for the selected channel will flash.
Press the channel selection button as many times as necessary until the indicator lights show the required
channel.
[2]. Control your equipment using the Open/On, STOP and Close/Off buttons on the monitor.
The equipment will react as stated in the table below:
13
of your electronics for 2 seconds (if this button
for the motorisation comes on then goes out.
. The "microphone activation" icon appears on the screen.
again, the monitor screen goes off and communication is cut off.
is lit on the

8. OPERATION

.
.
Video phone V100+
12
13
11
1
B
A
STOP
SELECT
STOP
Copyright © 2019 SOMFY ACTIVITES SA. All rights reserved.
C

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1870535

Table des Matières