Wireless Control Of Somfy Rts Equipment; Adding An Rts Device (Radio Technology Somfy); Removing Somfy Rts Equipment - SOMFY V300 Manuel D'installation Et D'utilisation

V300

7 WIRELESS CONTROL OF SOMFY RTS EQUIPMENT

The monitor is equipped with a Somfy Radio Technology (RTS) transmitter. It is only compatible with devices equipped with Somfy
Radio Technology (RTS).
It is used to control the following Somfy equipment, individually or simultaneously:
-
garage door motorisation,
-
lighting receiver,
-
roller blind motorisation,
-
gate motorisation. (for a SOMFY RTS gate motorisation sold in a DIY store, see "7.3.1 Saving the gate motorisation in the
monitor's memory"),
-
Etc.
This functionality is possible thanks to a system of radio channels identified by indicator lights at the bottom of the monitor. Each
channel corresponds to an individual remote control and can be used to control one or more devices. There is no limit to the number
of devices that can be controlled by a single channel. To control a channel, simply press one of the "open/on" (5), "stop" (6) or "close/
off" (7) buttons.
Important: Check that the equipment to be controlled is wireless and within the radio range of the monitor.

7.1 Adding an RTS device (radio technology Somfy)

To add an RTS device (radio technology Somfy), you must carry out 2 steps:
-
identify the original RTS control for the equipment (remote control, transmitter, etc.)
-
pair the monitor with the RTS device on the channel of your choice
7.1.1 Example: Adding a Somfy RTS roller shutter
[1]. Identify the original control of the roller shutter, i.e. the remote control or the control point which only controls this roller
shutter.
Note:
- If the original control is lost or broken, and it is the only one that controls the roller shutter, contact one of our Somfy
advisers.
- If another control operates the roller shutter, use that to follow the steps below.
[2]. Partially open the roller shutter using the original control.
[3]. Press the original control's PROG button for at least 3 seconds: the
product reacts (for example, with a brief up and down movement or
a series of 3 BEEPS). The programming function is activated for 2
minutes.
Note: If you cannot locate the PROG button on your control point, refer
to the instructions.
[4]. Select a free channel by pressing the "SELECT" button (8) on the
monitor.
[5]. Press the PROG button (14), located at the bottom right of the monitor,
for 1 second.
[6]. Check that pairing has worked by pressing an open or close button.
Specific case: adding an already occupied radio channel
You can save more than one item of Somfy RTS equipment on the same radio channel to create
groups of equipment. All equipment configured on the same channel then functions together.
To add a device, follow the procedure explained previously ("7.1 Adding an RTS device (radio
technology Somfy)"). When you are asked to select an already occupied channel, choose the
already occupied channel.
Note: It is recommended for optimum ergonomics, to group all equipment of the same type together on a single radio channel.

7.2 Removing Somfy RTS equipment

It is possible to delete control of a Somfy RTS device: when a device is already paired to the monitor, beginning the procedure
described above again cancels the pairing.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
Individual RTS control point
3
EN
3
14
1
15