Setting The Videophone; Monitor; Adjusting The Screen; Door Station - SOMFY V300 Manuel D'installation Et D'utilisation

EN

6.1 Monitor

12 Bell volume dial
13 Speaker volume dial

6.1.1 Adjusting the screen

[1]. Press the "Menu" button (15).
[2]. Press briefly on the "Menu" button to navigate through the settings menu: the setting selected is
highlighted in orange.
[3]. Press the settings buttons (16) to change the value of the parameter selected (brightness, contrast, menu
language, time or date) until the desired setting is obtained.
[4]. Press the "Back" button (17) to exit the menu.
6.1.2 Changing the monitor bell-tone
16 bell-tones are available on the monitor.
To change the monitor bell-tone, keep the "BACK" button (17) depressed (approx. 5 seconds). The default or previous bell-tone is
played. You can then listen to the other bell-tones using the "settings buttons". Once you have made your choice, press the "Back"
button briefly to save the new bell-tone.

6.2 Door station

6.2.1 Adjusting the speaker volume

To adjust the door station speaker volume, use a screwdriver to turn the
bottom potentiometer (7) at the rear of the door station:
-
clockwise to increase the volume,
-
anti-clockwise to reduce the volume.
6.2.2 Setting the bell tone volume from the door station
To adjust the door station bell-tone volume, use a screwdriver to turn the
top potentiometer (8) at the rear of the door station:
-
clockwise to increase the volume,
-
anti-clockwise to reduce the volume.
14

6 SETTING THE VIDEOPHONE

This is used to adjust the volume of the monitor bell.
This is used to adjust the volume of the monitor.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
V300
12
13
15
17
20 16
8
7