Installing The Monitor; Installation For One Residence; Installation For Two Residences - SOMFY V300 Manuel D'installation Et D'utilisation

EN
A specific procedure must be followed to programme a SOMFY RTS gate motorisation sold in DIY stores in radio control mode.
GATE MOTORISATIONS CONCERNED (a er 2010):
• EVOLVIA, SGA and PASSEO 800 arm motors
• EXAVIA, SGS cylinder motors
• FREEVIA, SLIDYMOOVE sliding motors
Attention
The following procedure must be carried out before the final installation of the monitor (the monitor must be placed next to the gate motor-
isation while powered by means of its mains adaptor)"7.3 Programming a Somfy RTS gate motorisation with integrated wireless control".

4.1 Installation for one residence

[1]. Fix the monitor mounting plate to the wall.
Important: The monitor mounting brackets must come out towards you.
Note: All the wires must pass inside the mounting bracket so they can be
connected to the monitor.
[2]. Remove the DC connector from the rear of the monitor, then connect
the mains adaptor cable to this connector: white wire with grey lines
at the top (+) and completely white wire at the bottom (-).
Important: It is essential to use the mains adaptor provided to power the
monitor.
Important: The mains adaptor must be installed close to the monitor and
must be easily accessible.
[3]. Connect the mains power adaptor connector to DC at the rear of the
monitor as shown in the illustration (screw to the le ).
Prepare the monitor for connection to the door station by connecting
a 2-wire cable to connector P1 at the rear of the monitor.
If you wish to install a second monitor, prepare the connection for this
monitor by connecting 2 wires to the P2 connector at the rear of the
monitor, then refer to the guide for the second monitor for additional
information on its wiring.
Note: For an installation for a single residence, the switch (18) must be
set to position 2.
2
[4]. Clip the monitor onto its mounting bracket by first positioning the top
of the monitor on the station, then the bottom.
Note: Position the mains power adapter wires between the mounting
bracket and the monitor.

4.2 Installation for two residences

8

4 INSTALLING THE MONITOR

1
18
Towards the second
monitor (optional)
To the door station
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
V300
-
-
+
+