Programming A Somfy Rts Gate Motorisation With Integrated Wireless Control; Saving The Gate Motorisation In The Monitor's Memory; Use; Responding To A Visitor - SOMFY V300 Manuel D'installation Et D'utilisation

EN

7.3 Programming a Somfy RTS gate motorisation with integrated wireless control

GATE MOTORISATIONS CONCERNED (a er 2010):
-
EVOLVIA, SGA and PASSEO 800 arm motors
-
EXAVIA, SGS cylinder motors
-
FREEVIA, SLIDYMOOVE sliding motors

7.3.1 Saving the gate motorisation in the monitor's memory

• Bring the monitor to the gate motorisation and connect it using the mains
adaptor (A).
• Open the motorisation cover to access the electronics
• Press on the power button
button does not exist, continue directly to the next step). The indicator light
is lit on the electronics.
• Place the lower central section of the monitor on the motorisation electronics
target (B).
• Select a free channel on the monitor and press the PROG button (14), located
at the bottom right of the monitor (C), for 1 second.
The indicator light
goes out.
• The motorisation is now saved in the monitor's memory. You can control the
opening and closing of your gate using the wireless control.
For more details, consult section concerning "Adding a 3-button remote control" in the
instruction manual of your SOMFY motorisation.

8.1 Responding to a visitor

Note:
Note:

8.2 Opening the gate

8.3 Unlocking the electric latch/lock

16
of your electronics for 2 seconds (if this
for the motorisation comes on then

8 USE

.
A pictogram
.
B B
A
.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
V300
14
C
1
"Back" button (17)
on your