Introduction To The Oven; Installation And Hook-Up; Before Hook-Up; Demonstration Mode - BORETTI BPO-45 Notice D'emploi

FOR ADDITIONAL INFORMATION about the treatment, recovery and recycling of this product, contact
the local office of competence, the domestic waste collection service or the store where the product was
purchased.
BEFORE SCRAPPING, make it unusable by cutting the electrical cord.
EN

Introduction to the oven

Dear Customer, your new oven is controlled by an electronic board that constantly monitors its operation
to improve its performance.
The touch controls are state-of-the-art, precise and reliable.
The interface is elegant, orderly and discrete, more intuitive than ever!
A few buttons, many functions and no combination or sequence is difficult to enter, so you can
concentrate on following the recipe and the oven is ready in two clicks!

Installation and hook-up

Dear Customer, this oven is a sophisticated electronic appliance, classified as a durable good. Its
installation requires qualified professionals for both the hook-up of the power line and itsplacement in
the kitchen counter.
(SEE ASSEMBLY INSTRUCTIONS ON PAGE 62)

Before hook-up

When the oven is connected to the electric mains for the first time, the display will ask you to select your
language;use the buttons to select the language you want;
use the button to confirm the choice;
(from now on, the language choice will remain fixed even when their are power outages).
Now, it goes into demonstration mode.

Demonstration mode

This is the mode that the oven is normally in every time that there is a power failure and, consequently,
when it is first hooked-up:
the purpose is to show how you can control it with a recorded sequence of commands.
39