Télécharger Imprimer la page

Güde UNI MIG 165 SYN Traduction Du Mode D'emploi D'origine page 41

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
Maintenance of the arc welding machines/
cutting equipment
Arc welding machines/cutting equipment
should be regularly maintained as per the
manufacturer's recommendations. All access
and service doors and covers should be closed
and well secured when the welding machine/
cutting equipment is in operation. With the
exception of the changes and adjustments
specied in the manuacturer's instructions, the
welding machines/cutting equipment should
not be modied in any way. In particular, the
spark gaps of arc ignition and stabilisation
devices should be adjusted and maintained in
accordance with the manufacturer's
recommendations.
Welding cables
Welding cables should be as short as possible,
close together, and should run across or near
the ground.
Electrical bonding
The electrical interconnection of all metallic
parts in and next to a welding machine/cutting
equipment should be taken into consideration.
Metallic parts connected to the workpiece can
increase the risk of the welder receiving an elec-
tric shock from touching these metallic parts
and the electrode at the same time. The welder
should be electrically insulated from all of these
connected metal parts.
Earthing the workpiece
It may be that the workpiece is not already
connected to earth for reasons of electrical
safety or because of its size and location, e.g. a
ship's hull or steel structures. If so, grounding
the workpiece can reduce emissions in some,
but not all, cases. Ensure that earthing the
workpiece does not increase the risk of accident
for the user or cause the destruction of other
electrical equipment. If necessary, the work-
piece must be grounded by a direct connection
to the workpiece. In countries where a direct
connection is prohibited, the connection should
be achieved using suitable capacitors, selected
in accordance with national regulations.
Screening
Selective screening o other cables and equip-
ment in the vicinity can reduce irradiation. The
screening of the entire welding/cutting set-up
may be considered for
special applications.
Class A (IEC 60974-10):
I you intend to use the apparatus in residential sur
roundings supplied by the low voltage mains supply,
an electromagnetic lter may be required to suppress
electrical disturbance to a level where they will no
longer be a nuisance to the user.
The apparatus may be used in industrial or other
areas where power is not supplied by municipal LV
mains.
Class A apparatus are not intended or use in residen
tial areas where power is supplied via municipal LV
mains, since unavourable power conditions may cau
se intererence. As a user, you must make sure, ater
consultation with your energy provider, i necessary,
that your point o connection on which the machine
is to be operated meets the requirements above.
The user is responsible or aults arising rom the
welding.
Symbols
Caution!
Read the Operating Instruc
tions!
Wear personal protective equipment.
Welding mask to be used!
Special welding gloves to be worn at all
times.
Wear saety cut through resistant shoes
with saety sole and steel toe !
Protective apron to be used
Beore carrying out any work on the
machine, disconnect the plug rom the
socket.
Pressure bottle to be secured by chain
Warning against dangerous
voltage
ENGLISH
33

Publicité

loading

Ce manuel est également adapté pour:

Uni mig 205 syn2007720083