Auxiliary Port For Usb Accessories; Acoustic Signalling Device; Grass Catcher Tipping Lever (If Foreseen, For Rear Collection Models Only); Push-Button Panel - Stiga MPST 84 Li 48 V1 Manuel D'utilisation

6.6 AUXILIARY PORT FOR
USB ACCESSORIES
This port (fig. 11.I) can be used to recharge
USB devices. It is only used for recharging.
The port has no communication function
with the connected USB device.
The port is only live when the key (11.A)
is turned into the drive position.
Do not charge the accessory connected to the
USB port in rainy, humid or high temperature
conditions with direct exposure to sunlight.
If used in these conditions the warranty
will be invalidated and the manufacturer
will not be held liable for any problems.
Do not open the cap of the USB
port in rainy or dusty areas.
The manufacturer declines all liability for damage
caused to the accessory connected to the USB
port or for any loss of data during its use.

6.7 ACOUSTIC SIGNALLING DEVICE

• The emission of a double sound signal
indicates the absence of the grass
catcher. Check the presence or correct
installation of the grass catcher (only
for models with rear collection).
• A continuous acoustic signal indicates that the
grass catcher is full. Proceed to empty it (see
par. 7.5.4) (only for models with rear collection).
• The emission of a single acoustic signal
indicates that no consent was given to
cut in reverse. See icon fig. 12.C.
6.8 GRASS CATCHER TIPPING
LEVER (IF FORESEEN, FOR REAR
COLLECTION MODELS ONLY)
This pull-out lever tips and empties
the grass catcher. This means less
work for the operator (fig. 11.E).

6.9 PUSH-BUTTON PANEL

Depending on the model, your machine may
be equipped with one of the push-button panel
versions (fig. 11.C, fig. 11.D) described below:
6.9.1 Push-button (type "I") Fig. 12
Machine start push-button
With the key in the drive
position, this push-button
(fig. 12.A) turns the machine
on and enables all functions.
Cutting means engage/
disengage push-button
By pressing the push-button
fig. 12.B the cutting means
are engaged/disengaged.
• When the cutting means
• By disengaging the cutting
NOTE
If the cutting means are
engaged without respecting the
safety conditions, the machine
will shut down or cannot be
turned on (see par. 7.2.2).
Reverse gear cutting
consent push-button
By keeping pressed the push-
button fig. 12.C the consent to
cut in reverse gear is given.
To cut in reverse gear, engage the
cutting means and hold down the
push-button at the same time.
NOTE
A single acoustic signal
indicates that no consent is
given to cut in reverse gear.
Headlight switch on button
By pressing the push-button
fig. 12.D the headlights
are switched on/off.
Caution Icon
The icon fig. 12.E, if lit, indicates
failure to comply with safety
conditions or a possible malfunction
of the machine (see chap. 15).
EN - 12
are engaged, they become
operational after a few seconds.
means, a brake is simultaneously
activated which stops their
rotation after a few seconds.