Stiga MPST 84 Li 48 V1 Manuel D'utilisation page 100

Battery LED
The LEDs fig. 12.F, numbered
from 1 to 5 starting from the left,
normally indicate the battery
charge level of the machine, but
specific combinations of their
illuminated status provide some
information regarding machine
malfunctions (see chap. 15).
6.9.2 Push-button (type "II") Fig. 12
Machine start push-button
With the key in the drive
position, this push-button
(Fig. 12.A) turns the machine
on and enables all functions.
NOTE
If all safety conditions are met,
the "READY" icon (fig. 12.K) is
lit and the machine is ready to
be used (see chapter 7.4).
Cutting means engage/
disengage push-button
By pressing the push-button
fig. 12.B the cutting means
are engaged/disengaged.
• When the cutting means
are engaged, they become
operational after a few seconds.
• By disengaging the cutting
means, a brake is simultaneously
activated which stops their
rotation after a few seconds.
NOTE
If the cutting means are
engaged without respecting the
safety conditions, the machine
will shut down or cannot be
turned on (see par. 7.2.2).
Reverse gear cutting
consent push-button
By keeping pressed the push-
button fig. 12.C the consent to
cut in reverse gear is given.
To cut in reverse gear, engage the
cutting means and hold down the
push-button at the same time.
NOTE
A single acoustic signal
indicates that no consent is
given to cut in reverse gear.
Headlight switch on button
By pressing the push-button
fig. 12.D the headlights
are switched on/off.
With the headlights on,
the icon fig. 12.L. is lit.
"CRUISE CONTROL" push button
Pressing the push-button
fig. 12.G activates/deactivates the
"CRUISE CONTROL "function.
The Cruise Control is a command
which allows to maintain the
desired speed in forward gear,
without the need to keep the
drive pedal pressed down.
• By pressing the "CRUISE
NOTE
In reverse gear it is not possible
to activate the "CRUISE
CONTROL" function.
NOTE
Speed may vary from that set
when going up or down hill.
To switch the device off and reset
the drive speed control using the
drive pedal (fig. 11.F) it is sufficient:
• to press the push-button fig. 12.G
• press the drive pedal (fig. 11.F).
EN - 13
CONTROL" push-button
(fig. 12.G) while driving forward,
the machine maintains the speed
reached at that moment, without
having to operate the drive pedal
(fig. 11.E). When the function is
active, the icon fig. 12.I. lights
up on the push-button panel.
or