Auxiliary Socket For Accessories; Grass Catcher Tipping Command; Type "I" Display And Buzzers; Type "Ii" Display And Buzzers - Stiga T 102 Série Manuel D'utilisation

5.14 AUXILIARY SOCKET
FOR ACCESSORIES
This socket can be used to connect
electrical devices that run off a 12 Volt dc
power supply, with a maximum power rating
of 50 Watt, and fitted with a compatible
plug (motoring type plug) (fig. 15.M).
– The socket is live only when the key
(fig. 15.A) is in the «ON» position.
5.15 GRASS CATCHER
TIPPING COMMAND
• Manual command
To tip the grass catcher bag in order to
empty it, the operator must extract the
lever (fig. 15.L) from its housing .
• Electrical command
To tip the grass catcher bag in order
to empty it, the operator must press
and hold the button (fig. 15.N) until the
command motor stops running.
The grass catcher is returned to the working
position by pressing and holding the button
(fig. 15.O) until the retaining catch locks into
place and the command motor stops running.

5.16 TYPE "I" DISPLAY AND BUZZERS

When the key is turned to the «ON» position,
all the indicator lights switch on for about half
a second (accompanied by a short acoustic
signal) to indicate that they function correctly.
Thereafter, these lights indicate:
Indicator light ON: cutting
devices engaged (Fig. 16.A).
Indicator light ON: parking
brake engaged (Fig. 16.B).
Indicator light ON: operator
not present (Fig. 16.C).
Flashing indicator light: fuel
is in reserve (Fig. 16.D).
Flashing indicator light: engine
lubrication faults (Fig. 16.E). Stop
engine immediately, check oil level and
contact an Authorized Service Centre.
Indicator light ON: grass catcher or rear
discharge guard missing (Fig. 16F);
Indicator light ON: when the engine
is running there are battery re-
charging faults (Fig. 16.G).
Flashing indicator light before start-
up: the battery is unable to start
the engine. Contact an Authorized
Service Centre (Fig. 16.G).
Indicator light ON: transmission
in "neutral" (Fig. 16.H).
• Acoustic signals - Buzzer
There are two types of acoustic signal:
1. Continuous
acoustic signal:
2. Intermittent
acoustic signal:

5.17 TYPE "II" DISPLAY AND BUZZERS

When the key is turned to the «ON» position,
all the icons switch on for about half a second
(accompanied by a short acoustic signal)
to indicate that they function correctly, then
the display goes into "Timer" mode.
Thereafter, these lights indicate:
Indicator light ON: cutting
devices engaged (Fig. 16.A).
Indicator light ON: parking
brake engaged (Fig. 16.B).
Indicator light ON: operator
not present (Fig. 16.C).
Simple fuel indicator light (Fig. 16.D).
Flashing indicator light: fuel is in reserve.
EN - 13
• Electronic card protection
system has intervened.
• The engine has been
switched off for more than
30 seconds with the key
in the "DRIVE" position.
• The grass catcher is full.