Stiga MPST 84 Li 48 V1 Manuel D'utilisation page 114

6. [Push-button panel Type I]
The icon fig. 12.E stays on
and the battery LEDs 2 and
4 flash.
[Push-button panel Type
II] The icons fig. 12.E and
fig. 12.N stay on and the
battery LEDs 2 and 4 flash.
7. The icon fig. 12.E stays on
and the battery LEDs 4 and
5 flash.
8. [Push-button panel Type I]
The icon fig. 12.E stays on
and the battery LEDs 1 and
3 flash.
[Push-button panel Type II]
The icons fig. 12.E and
fig. 12.N stay on and the
battery LEDs 1 and 3 flash.
9. The icon fig. 12.E stays on
and the battery LEDs1, 3
and 5 flash.
overheating/sub-heating
of the battery due to:
1. Heavy working
conditions.
2. Unsuitable
environmental
conditions.
Current overload on the
cutting means due to:
1. Heavy working
conditions.
2. Obstructions
hindering the rotation
of the cutting means.
3. Cutting-means
assembly is full of
grass.
Cutting means motors
overheating due to:
Heavy working
conditions.
Cutting means motors
stalling due to:
1. Heavy working
conditions.
2. Obstructions
hindering the rotation
of the cutting means.
3. Cutting-means
assembly is full of
grass.
EN - 27
Turn the machine off, wait at least 5 minutes and then
re-start it.
Reduce the travel speed
Increase the cutting height:
Work in an environment suitable to the machine
operational conditions.
Reduce the travel speed
Increase the cutting height:
Remove the obstructions.
Clean the cutting-means assembly.
Turn the machine off, wait at least 5 minutes and then
re-start it.
Reduce the travel speed
Increase the cutting height:
Reduce the travel speed
Increase the cutting height:
Remove the obstructions.
Clean the cutting-means assembly.