Publicité
Les langues disponibles
Les langues disponibles
Operation
3.20 Stopping/Parking
See Graphic: wc_gr002954
3.20.1 Stop the machine on a flat surface with a suitable load bearing
3.20.2 Turn the vibration off by pressing the vibration control button (10) on
3.20.3 Press the water spray switch (61) to the OFF position.
3.20.4 Set the forward/reverse control (15) to the NEUTRAL position.
3.20.5 Return the engine throttle to idle by pressing the lower half of the
3.20.6 Press the parking brake button (42) to set the parking brake. Always
WARNING
3.20.7 Stop the engine by turning the starting switch to the OFF position (55).
All manuals and user guides at all-guides.com
capacity.
the forward/reverse lever (15).
throttle switch (54) and allow the engine to cool down.
set the parking brake before leaving the machine.
If the vehicle constitutes a hazard or obstacle to traffic when parked, it
should be marked with signs, lights, and other warnings.
If the machine must be parked on a sloping surface, chock the drums
with wedges to prevent any vehicle movement.
Note: On the RD 16, the parking brake is automatically applied within
the drive motors. The brakes are applied under the following
conditions:
•
engine is not running
•
engine is running and the operator is not on the seat
•
parking brake button is pushed
50
RD 16
wc_tx001075gb.fm
Publicité
