Wacker Neuson RD 16 Manuel De L'opérateur page 48

Operation
3.19 Starting
See Graphic: wc_gr002952
WARNING
3.19.1 Sit down in the operator's seat and fasten the seat belt.
3.19.2 Set the forward/reverse control (15) in the NEUTRAL position.
3.19.3 Press the parking brake button in (42) to set parking brake.
3.19.4 Turn the starting switch (55) to the ON position. The glow plug indicator
3.19.5 Turn the starting switch (55) to the START position.
3.19.6 Allow the engine to warm up for a few minutes before operating the
3.19.7 Disengage the parking brake by pulling the parking brake button out.
3.19.8 Quickly press and release the upper half of the throttle switch (54) to
WARNING
All manuals and user guides at all-guides.com
Exhaust gases are toxic. Do not start the engine in enclosed spaces.
Note: The roller will not start unless the forward/reverse control is in
the NEUTRAL position.
(58) will illuminate signifying the glow plugs are on. The glow plug
indicator will stay on; approximately 30 seconds at 0°C (32°F). Do not
start the engine until the glow plug indicator light goes out.
NOTICE: Do not crank the engine starter for more than 15 seconds at
one time. Longer cranking cycles could lead to starter damage.
Note: The starting switch has an anti-restart feature. If the engine does
not start, the switch will need to be turned to the OFF position before it
will allow the engine to be cranked again.
roller.
bring the engine to high throttle.
Prolonged exposure to high noise levels can damage your hearing.
Wear appropriate hearing protection while operating the roller.
48
RD 16
wc_tx001075gb.fm