Publicité
Les langues disponibles
Les langues disponibles
Status
Fault
•
Battery may not be mak-
ing proper electrical contact
with the charger.
•
Battery is not an IMPRES 2
battery.
•
An unknown condition is
preventing the battery from
being discharged.
•
Charging was completed
before the Long-Term Stor-
age goal could be reached.
•
The charger pocket is a
special type.
Standby
•
Battery is waiting to rapid
charge.
•
Battery may be too hot, too
cold, or low voltage.
•
Charger may be too hot
Long-Term Storage of an IMPRES 2 Battery, must discharge down to
SelectionLong-Term Storage of an IMPRES 2 or IMPRES Battery-Calibrated
Battery, must discharge down to Selection
Table 15: Long-Term Storage of an IMPRES 2 Battery, must discharge down to Selection
Status
Charger Powers On
Battery Detected
Battery Discharging
Long-Term Storage Complete
Chapter 5 : Battery Preparation for Long-Term Storage
Charger Display
WARNING: NOT
CHARGEABLE RE-
MOVE& REINSERT
or WRONG BATT
TYPE CANNOT LT
STORE or CAN-
NOT DISCHARGE
FOR LT STORAGE
or STORE INCOM-
PLETE Low Ca-
pacity:yy% or RA-
DIO POCKET CAN-
NOT LT STORE or
CHARGING POCKET
CANNOT LT STORE
WARNING: HOT
BATTERY WAITING
TO CHRGE or COLD
BATTERY WAITING
TO CHRGE or
VERY LOW BAT-
TERY WAITING TO
CHRGE or HOT
CHARGER WAITING
TO CHRGE
Charger Display
IMPRES 2 CHARGER
IMPRES 2 BATTERY
STORAGE CHARGE xxx%
Rated Cap
LONGTERM STORAGE xxx%
Rated Cap
MN008454A01-AB
LED Indicator
Blinking Red
Blinking Amber
LED Indicator
Green for approximately one
second
Steady Red
Steady Amber
Steady Green
29
Publicité
