Publicité
Les langues disponibles
Les langues disponibles
2 Within 2.5 minutes, remove the battery from the charger pocket.
3 Within five seconds, reinsert the battery into the charger pocket.
Calibration or reconditioning starts immediately, beginning with battery discharge, indicated by steady
amber LED. Calibration or reconditioning is complete only after full charge, indicated by steady green
LED.
3.7
End-of-Service-Life Indication
The IMPRES 2 charger may indicate IMPRES 2 battery end-of-service by alternating red and green
LED upon successful completion of calibration or reconditioning. For battery with Self Calibration icon,
the charger may indicate the battery End-of-Service momentarily at battery insert, and continuously
blinks red and green LED upon complete charging.
When batteries are used, normal wear reduces available capacity. IMPRES 2 chargers compare
IMPRES 2 battery capacity to the battery rated capacity. When the capacity is at a very low value, the
IMPRES 2 battery may be nearing its end-of-service. The IMPRES 2 battery remains usable. In some
scenarios, it may be preferable to deploy the battery to someone who does not require large battery
capacity to complete a work shift.
APX NEXT XN battery comes with high temperature detection feature that is detectable from IMPRES
2 charger with software version V2.05 or newer. When this feature is enabled, the status LED
flashes red and green alternately upon charge completion for battery that went through prolonged
exposure (exceeding 10 minutes cumulatively) under extreme high temperature environment. The
charger displays the following:
REPLACE BATTERY
EXPOSED OVERTEMP
It is recommended to remove this battery out from the service.
3.8
Manually Terminating Calibration or Reconditioning
At any time during IMPRES 2 battery discharge (Steady Amber), calibration or reconditioning may be
terminated.
When and where to use: To manually terminate calibration or reconditioning, perform the following
steps:
Procedure:
1 Remove the battery from the charger pocket.
2 Within five seconds, reinsert the battery into the charger pocket.
Battery discharge immediately terminates, and normal battery charging starts. The LED indicates
charge status.
Chapter 3 : IMPRES 2 Batteries and Chargers
MN008454A01-AB
17
Publicité
