Publicité
Les langues disponibles
Les langues disponibles
Figure 3: Charging Stand-Alone Battery
Procedure:
1 Place the charger on a flat surface.
2 Firmly insert the power cord into the charger AC inlet socket on the back of the charger.
3 Plug the power cord into a matching power outlet.
Upon successful power-up, each charge status LED flashes green for approximately one second
and displays IMPRES 2 CHARGER. If the charger status LEDs does not flash and no message
is displayed, check both power cord connections.
4 Insert a radio with attached battery or a stand-alone battery into an available pocket.
NOTE: Grip the body of the radio when inserting or removing it from the charger. Avoid
pulling the radio antenna.
Flip up the swivel adaptor to charge PMNN4816_ battery. The swivel adaptor position is flat
down for other batteries.
Figure 4: Swivel Adaptor Position
Table 6: Swivel Adaptor Position and Description
Item
1
1
Description
Blue color label is shown when the swivel adaptor is in the flipped up
position.
MN008454A01-AB
Chapter 4 : Charger Overview
2
19
Publicité
