Motorola PMPN4591 Mode D'emploi page 31

Chapter 6
Lithium-Ion Battery Preparation for
Shipment
You can prepare IMPRES 2 or other Motorola Solutions Lithium-Ion batteries for shipment by air cargo
using an IMPRES 2 Multi-Unit Charger. Other battery types are faulted.
Prepare only stand-alone Motorola Solutions Lithium-Ion batteries for shipment. Remove the battery
from the radio before placing it into the charger.
Do not store a stand-alone battery in the charger. When preparation for Lithium shipment is
complete, immediately remove the stand-alone battery from the charger. Selection of Lithium shipment
supersedes calibration or reconditioning.
6.1
IMPRES 2 Battery
Preparing a Lithium-ion Battery for Shipment-IMPRES 2 Battery is due for
Calibration
Table 16: Preparing a Lithium-ion Battery for Shipment-IMPRES 2 Battery is due for Calibration
Status
Charger Powers On
Battery Detected
Battery Discharging
Rapid Charging
Ship Lithium Complete
Charger Display
IMPRES 2 CHARGER
IMPRES 2 BATTERY
SHIP LI DISCHRGE xxx%
Rated Cap
SHIP LI CHARGE xxx%
Rated Cap
LI READY TO SHIP xxx%
Rated Cap
MN008454A01-AB
Lithium-Ion Battery Preparation for Shipment
LED Indicator
Green for approximately one
second
Battery requires Calibration:
Alternating Amber and Green
for four seconds
Steady Amber
Steady Red
Alternating Amber and Green
31