Publicité
Les langues disponibles
Les langues disponibles
MN008454A01-AB
Chapter 13 : Pocket Insert Installation
Figure 29: The ferrite cores part of the cable positioning
11 Rotate the pocket around and align it to the charger. The wires are half twisted. Do not pull up
on the wire harness.
The screw hole of the pocket aligns to the hole in the charger.
12 Re-install the T10 screw and tighten to 6 in-lbs.
13 Slide the rear shroud onto the unit. To reinstall the hood, slide both sides forward and lock the
tabs into place.
Figure 30: Hood Re-installation
62
Publicité
