Motorola PMPN4591 Mode D'emploi page 11

Chapter 2
Charger, Pocket, and
Communications Interface
APX NEXT Series IMPRES 2
The charger is equipped with the following additional features:
• Adaptive charging to accommodate a wide variety of battery types, including IMPRES 2 and other
authentic Motorola Solutions batteries.
• Pocket that accommodates either a stand-alone battery or a radio with an attached battery.
• Red/Amber/Green LED indicating the charger pocket status.
• Communications Module:
- Programming for charger reprogramming.
- IMPRES 2 battery data upload to the IMPRES 2 Battery Fleet Management System.
- Six USB Type A charging ports, each with 0.5 A for charging a USB accessory.
• Keypad Menu:
- Charger Setup.
- Battery Analysis.
• Information display on Pockets.
• Preparation of a stand-alone IMPRES 2 battery for a long-term storage or preparation of a stand-
alone Motorola Solutions Lithium-Ion battery for shipment. Do not leave batteries in the charger
after the preparation for Long-Term Storage or Lithium-Ion Shipment is complete.
• Higher-rate IMPRES 2 Lithium-Ion battery charging.
• Faster charging.
• Extended battery life cycle.
Operation of a radio while it is in the charger is not recommended.
During the charging process, radio operation may result in a minimally reduced radio performance and
an extended battery charge time.
™
Adaptive Charger System is a fully automated battery care system.
Charger, Pocket, and Communications Interface
MN008454A01-AB
11