Publicité
Les langues disponibles
Les langues disponibles
MN008454A01-AB
Chapter 4 : Charger Overview
Item
2
When the radio or stand-alone battery is properly seated in the pocket, charging status is
indicated by the associated charge status LED. The associated display provides additional
information.
The battery is ready for use when the charging status is steady green.
4.2
Charging USB Accessories
When and where to use: Some IMPRES 2 Multi-Unit Charger Communications Modules provide USB
Type-A sockets to charge USB accessories. USB accessories charge best at room temperature.
Procedure:
1 Place the IMPRES 2 Adaptive Charger on a flat surface.
2 Firmly insert the power cord into the charger AC Socket on the back of the charger.
3 Plug the power cord into a matching power outlet.
Upon successful power-up, each pocket Status LED flashes Green for one second and displays
IMPRES 2 CHARGER. If the Status LEDs do not flash and no message is displayed, check
power cord connections.
4 Orient the USB cable Type A plug to align properly with a Type A port on the Communications
Module. Insert the plug into the port.
A USB accessory can have one Micro-AB receptacle for charging. Use a standard 1-meter or
shorter USB cable with a Type A plug on one end and an accessory compatible plug on the
other end, typically Micro-B or Micro-AB.
5 Orient the USB cable Type A plug to align properly with a Type A port on the Communications
Module. Insert the plug into the port.
6 Orient the USB cable Micro-B plug to align properly with the Micro-AB receptacle on the USB
accessory. Insert the plug into the receptacle.
When the USB connections are properly seated, the charging status is indicated by the USB
accessory. Refer to the USB accessory User Guide for details.
4.3
Charging Indications
This sections describes the charging indications when using the charger.
20
Description
Yellow color label is shown when swivel adaptor is in the flat down
position.
Publicité
