Publicité
Les langues disponibles
Les langues disponibles
4.3.1
IMPRES 2 Battery
Table 7: Charging Indications for IMPRES 2 Batteries-Calibration Not Required
Status
Charger Powers On
Battery Detected
Rapid Charging
Charged to 90 % or more
Charged to 95 % or more
Fault
Standby
•
Battery is waiting to rapid
charge
•
Battery is too hot, too cold,
or low voltage.
•
Charger is too hot.
NOTE:
•
The Hot Charger message is introduced in V1.05 software.
•
State of Charger percentage indications, with respect to potential capacity versus
rated capacity, is introduced in V1.11.01 software.
Table 8: Calibrating Indications for IMPRES 2 Batteries Calibration-Calibration Enabled
Status
Charger Powers On
Pocket Display
IMPRES 2 CHARGER
IMPRES 2 BATTERY
RAPID CHARGE XXXX0mAh
yyy%Ptl
TRICKLE CHARGE
xxxx0mAh yyy%Ptl
CHARGE COMPLETE
xxxx0mAh yyy%Ptl
WARNING: NOT
CHARGEABLE RE-
MOVE& REINSERT
WARNING: HOT
BATTERY WAITING
TO CHRGE or COLD
BATTERY WAITING
TO CHRGE or
VERY LOW BAT-
TERY WAITING TO
CHRGE or HOT
CHARGER WAITING
TO CHRGE
Pocket Display
IMPRES 2 CHARGER
MN008454A01-AB
Chapter 4 : Charger Overview
LED Indicator
Green for approximately one
second
Steady Red
Steady Red
Blinking Green
Steady Green
Blinking Red
Blinking Amber
LED Indicator
Green for approximately one
second
21
Publicité
